does the arduino wire library use interrupts

Does the arduino wire library use interrupts serial#

I2C addressesĮach secondary device therefore has a unique address which takes the form of a hexadecimal string, for example 0圆9. Most of the time, the speed is less than 1 Mbit/s, in general it is between 100 and 400 kbit/s for the sensors. The maximum speed is imposed by the manufacturer. Ultra-fast mode (UFm) ≤ 5 Mbit/s, unidirectional only.Note that it is very rare to exceed 10 devices per assembly in the majority of connected object projects. The two lines must be connected to a reference voltage (Vdd) via pull-up resistors. The signal is generated only by the main equipmentįrom an electrical point of view, all equipment must be connected to the same GND electrical ground. SCL (Serial Clock Line), bidirectional synchronization clock line.SDA (Serial Data Line), bidirectional data line,.The I2C bus only requires two communication lines (wires) to connect devices to each other: Most of the time, the I2C bus consists of a main device and one or more secondary devices, but the standard allows more complex organizations.

Does the arduino wire library use interrupts serial#

The I2C bus is therefore an improvement in serial communication intended to communicate home automation accessories developed from the 1980s by Philipps. However, we will not discuss the technical operation of the I2C bus which is already very well explained on this Wikipedia page. In this article, we will discuss the operating principle of the Wire.h library, which allows Arduino to communicate easily with each other.